AEROFLEX
closed
cell tube insulation is easily installed to pipes or tubing.
The factory-applied coating of talcum powder on the thick
and smooth inner skin helps speed up preassembly lines.
When applied to existing lines tubing should be slit length-wise
and snapped into place. Slitting can be done on the job
easily with razors, blades, knives ,or shears. Cut edges
and joints can be sealed with Aeroseal Adhesive (neoprene
base contact cement).
The
standard sheet is availible in size of 36" x 48"
with a wall thickness from 1/8" to 2" and 0.5mx2m
with a wall thickness from 3mm upto 50mm. It prevents
heat loss and condensation on large pipelines, tanks,
chillers, air ducts, and other irregular shaped vessels.
The
pre-cut sheets are ready-cut in sizes to suit large pipe
sizes ranging from 4" IPS upwards (1/2" to 2"
wall thickness are available in 48" length). The
pre-cut series makes fabrication easier and more economical
because wastage is eliminated. Moreover, AEROFLEX precut
sheet is manufactured to nominal thickness with smooth
and dense skins on both surfaces. In addition to excellent
insulating properties, the pre-cut sheet also has greater
resistance to water vapor penetration and water absorption.
AEROFLEX
sheet insulations are also available in continuous roll
form. Aeroflex continuous sheet rolls are available from
1/8" (3 mm) to 2" (50 mm) thickness, 48"
(1, 220 mm) width x 13' to 100' length or 1,000mm width
x 3 m to 30 m length. All insulating sheets are made from
the same materials as Aeroflex tubing.
AEROFLEX
closed
cell tube insulation is easily installed to pipes or tubing.
The factory-applied coating of talcum powder on the thick
and smooth inner skin helps speed up preassembly lines.
When applied to existing lines tubing should be slit length-wise
and snapped into place. Slitting can be done on the job
easily with razors, blades, knives ,or shears. Cut edges
and joints can be sealed with Aeroseal Adhesive (neoprene
base contact cement).
The
standard sheet is availible in size of 36" x 48"
with a wall thickness from 1/8" to 2" and 0.5mx2m
with a wall thickness from 3mm upto 50mm. It prevents
heat loss and condensation on large pipelines, tanks,
chillers, air ducts, and other irregular shaped vessels.
The
pre-cut sheets are ready-cut in sizes to suit large pipe
sizes ranging from 4" IPS upwards (1/2" to 2"
wall thickness are available in 48" length). The
pre-cut series makes fabrication easier and more economical
because wastage is eliminated. Moreover, AEROFLEX precut
sheet is manufactured to nominal thickness with smooth
and dense skins on both surfaces. In addition to excellent
insulating properties, the pre-cut sheet also has greater
resistance to water vapor penetration and water absorption.
AEROFLEX
sheet insulations are also available in continuous roll
form. Aeroflex continuous sheet rolls are available from
1/8" (3 mm) to 2" (50 mm) thickness, 48"
(1, 220 mm) width x 13' to 100' length or 1,000mm width
x 3 m to 30 m length. All insulating sheets are made from
the same materials as Aeroflex tubing. 
